MERV 10 Panel Filter

Features

MERV 10 rated filter
Low initial resistance at 500 fpm
More media & better efficiency
Filter is not affected by moisture.
Will not warp or collapse when wet.
Spor-Ax® Antimicrobial agent
Cost is similar to many pleated filters.
Easy to install and remove

CALL TODAY!
1-800-699-0747

MERV 10 Panel Filter by Fiberbond

MERV 10 Panel Air Filter

SECURITY AGAINGST PRODUCT FAILURE

The MERV 10 panel filter single and continuous filters are made to withstand the most severe conditions. A high strength internal 'X' grid assures filters stay in place. No chipboard frame to collapse. No falling out of frames or side access tracks.

NO UNFILTERED AIR BETWEEN FILTERS

The use of individual pleat filters in side access units presents the concern of gaps between filters allowing unfiltered air downstream to contaminate coils and work areas. MERV 10 panel filters are continuous units. No space between - no dirt passing between.

NO MOLD GROWTH ON FILTERS

MERV 10 panel filters with Spor-Ax antimicrobial will not support microbial growth on the filter. No early change outs from mold growth on filter media or paper board frames.

APPLICATIONS

Used in commercial and industrial air filtration systems. When clean air is important.

Used in > Casinos, Hospitals, Universities, Restaurants, Airports, Office Buildings, and more.

True MERV 10 without temporary electrostatic enhancement.

Higher efficiency for the life of the filter than any pleat.

Initial resistance: 0.32" to 0.35" at 500fpm
ASHRAE 52.2 performance: Conditional step: No drop off MERV 10 at 492 fpm
80% efficiency on 3 microns
Recommended discard: 1.0" w.g.
Temperature limit: 200° F

CALL TODAY!
1-800-699-0747